Ghost not binding

Check the firmware version in the RX, this can be done easily by holding down the RX button whilst powering it on, then count the number of LED flashes on each colour for the firmware version.  This is described in detail in the manual, scroll down to Rx ‘Unbricking’.

Once the RX firmware version is established install the matching firmware in the TX and bind the TX and RX, after a successful bind then upgrade to the latest firmware version.

If Ghost will still not bind then you need to establish if the TX is transmitting packets.  Using an ImmersionRC RF Power Meter in scope mode, (push joystick to the right after power up), to verify that the TX is transmitting packets.  Either connect the Power meter directly to one of the Ghost antenna connectors using the RP-SMA adapter or with the Ghost antenna connected use the power meter sniffer antenna.  Both Antenna should be tested.  If no packets are being transmitted then there may be a fault with the TX and you should contact your retailer or ImmersionRC support for assistance.